I finally basted my teddy bear quilt. I did the safety pin basting method, and it was so much less time consuming than hand basting. I usually hand baste, but now, whenever I can I safety pin baste, because it is a huge time saver. I’m not abandoning hand basting forever, because I have four WIP that are king size quilts, and I don’t think safety pin basting will keep the three layers smooth and taut when I quilt them together, and that is key for successful basting, quilting and finishing.
As some may know, a quilt is like a sandwich, and is made up of three layers; the top, the batting and the bottom. The three layers need to be firmly structured together for the quilting part of the process, and when finished, the safety pins, or hand basting thread are then removed.
It is not a good thing when the three layers shift while quilting, because then you get an icky pocket or bump in the back, and it’s there forever, because ripping out all your quilting and going back to the basting stage takes an enormous amount of time, and is painstaking. (This is the voice of experience talking, so take my word for it). Make sure you’ve basted the three layers so they are completely smooth and flat, before you begin quilting. The goal is to have all three layers smooth and flat when you are finished quilting.
Below is a diagram of the quilting sandwich concept 🙂
Isn’t it easier to visualize a concept when fun food is involved?
So I am using big clips to clamp down my bottom layer, or backing on a high and large table,courtesy of my favorite place to quilt, and hang out with other creative and interesting quilters, Pins and Needles in Mt. Kisco,NY. I have known the owners, a Mother -Daughter team, Deb and Lisa,for 15 years, and they are the nicest people and fabulous teachers.
These clips can be bought at any store where they sell office supplies, such as Staples or Office Depot. When I baste big king size quilts, I use these big yellow clamps which I bought at Home Depot.
Here is the backing layer, clipped down.
Because the end of the quilt doesn’t reach the end of the table, we used packing tape to secure that end down securely. I usually use 2″ blue painters tape which works really well too.
The next step is to place the batting on top of the backing layer, and smooth it out from the middle to the edges. By the way, both the backing layer and the batting are at least 4″ larger in diameter than the quilt top. This is important because, not only will I need a little extra room to add my binding to the quilt after I’ve machine quilted the three layers, but the extra room provides insurance that the quilt top won’t overlap the batting and the backing layer.
Then the top is added and smoothed out from the middle to the edges, but not clamped to the other two layers. If I were hand basting, I would have included all three layers in the clamps.
I started safety pinning from the middle out in an X shape. Then from the middle, top to bottom and across the sides in a cross shape. Then I randomly filled in with safety pins in spaces where I thought the extra security would be useful so no bunching would happen on the back.
And there you go!! Happy Quilting.
We’ve made a lot of progress on the new sewing room, and one of my king size WIP. I am excited to show how both are shaping up later this week.